Journal of Heat and Mass Transfer Research

Journal of Heat and Mass Transfer Research

Numerical Investigation of the Melting Dynamics of a Phase Change Material in a Fin-Finned Heat Sink Containing Metal Foam with Different Porosities

Document Type : Full Length Research Article

Authors
Department of Mechanical Engineering, CT.C., Islamic Azad University, Tehran, Iran
10.22075/jhmtr.2026.42390.2012
Abstract
Driven by the escalating power density and heat fluxes in modern electronic components, passive thermal management systems employing phase change materials (PCMs) have emerged as highly viable solutions due to their high latent heat storage capacities. However, the commercial deployment of PCMs is severely hindered by their low thermal conductivity, which limits heat dissipation rates. To address this bottleneck, this study presents a comprehensive numerical investigation into the thermal performance of a composite PCM-metal foam heat sink. The governing conservation equations were solved using the finite volume method (FVM) in ANSYS Fluent, utilizing the local thermal non-equilibrium (LTNE) model to accurately capture the thermal transport between the solid metal skeleton and the PCM. The influence of the porous structure was evaluated by systematically varying the porosity 0.85, 0.90 and 0.95. The numerical results indicate that integrating the porous metal foam significantly enhances the effective thermal conductivity, thereby accelerating the phase change rate compared to pure paraffin. Specifically, the complete melting time was reduced from 1850 s in the pure PCM case to 1650 s, 1600 s and 1550 for porosities of 0.95, 0.9 and 0.85respectively, yielding a maximum melting time reduction of 16.2%. Furthermore, a parametric analysis revealed that increasing porosity prolongs the melting duration because the reduced volume fraction of the conductive metal matrix diminishes the bulk effective thermal conductivity. Ultimately, while the lowest porosity of 0.85 maximizes the heat transfer rate and minimizes the melting duration, the highest porosity of 0.95 provides superior long-term thermal stability due to the delayed and gradual utilization of the latent heat capacity. These findings yield critical design guidelines for optimizing composite PCM heat sinks in high-heat-flux electronic cooling applications.
Keywords
Subjects


Articles in Press, Accepted Manuscript
Available Online from 20 November 2026

  • Receive Date 21 August 2026
  • Revise Date 20 October 2026
  • Accept Date 20 November 2026